Enphase Terminator cap for unused 1-phase cable ends

Enphase
Q-TERM-R-10
3 In stock
ENERGY : Solar PV Balance Of System
The Enphase Terminator Cap, also known as the Q-TERM-R-10, is a device used to seal off unused open ends of a single-phase Q-Cable run. This is important for a number of reasons, including ensuring the safety of the system and preventing moisture or debris from entering the cable run. Most...

The Enphase Terminator Cap, also known as the Q-TERM-R-10, is a device used to seal off unused open ends of a single-phase Q-Cable run. This is important for a number of reasons, including ensuring the safety of the system and preventing moisture or debris from entering the cable run. Most Enphase systems will require at least one Terminator Cap.

The Q-TERM-R-10 is an end-terminating device that is designed to latch onto the end of the cable run and provide a secure seal. Once the Terminator Cap is in place, it is not recommended to open it again, as doing so will destroy the latching mechanism. This damage may not be visible to the naked eye, so it is important to handle the Terminator Cap carefully to ensure that it remains intact.

The Enphase Terminator Cap is supplied in a bag of ten, making it easy for installers to have enough caps on hand for their installation needs. Using the Terminator Cap is simple - just insert the open end of the Q-Cable run into the cap and latch it securely in place.

Overall, the Enphase Terminator Cap is an essential accessory for any Enphase single-phase Q-Cable installation. It helps to ensure the safety and reliability of the system, and is designed to provide a secure seal that will last for the life of the system.

Enphase training

Enphase Training

This course teaches you all about Enphase microinverters. It will show you were the Enphase microinverters are connected, how they are connected to the Enphase module and to the DB board, and all the benefits of Enphase microinverters. It will also teach you all about how to access the Enphase module via Wifi and show you all the monitoring capabilities.

Learning Management System now available to all Rubicon eCommerce account holders

Complete this course to get points towards your Rubicon Glass score for Lead referrals.

Parameter

Design: Enphase Q Cable branch terminator for 1 ph. Q Cable (10)

UV exposure rating: EN ISO 492-2

Compliance: RoHS, OIL RES I, CE, UV resistant

Cable insulator rating: H07BQ-F

Flame rating: IEC 60332-1-2


Electrical data

Voltage rating: 600V (connector rating up to 250 V)

Cable temperature rating: 90° C wet/dry


Ambient conditions

Environmental protection rating: IEC 60529 IP67

Enphase Terminator cap for unused 1-phase cable ends
You have successfully subscribed!
This email has been registered