Enphase Relay controller, 4-pole, 1/2/3 phase, 25A

Enphase
Q-RELAY-3P-INT
22 In stock
ENERGY : Solar PV Balance Of System
Meet the Q Relay behind smart energy. External relay acts as a grid monitoring and disconnection device. Automatically reconnects when valid grid conditions resume. Three-phase In Enphase installations, the Q Relay (network system relay controller) acts as a physical disconnection device relay controller for single-phase installations. During specified grid abnormalities,...

Meet the Q Relay behind smart energy.

External relay acts as a grid monitoring and disconnection device. Automatically reconnects when valid grid conditions resume. Three-phase
In Enphase installations, the Q Relay (network system relay controller) acts as a physical disconnection device relay controller for single-phase installations. During specified grid abnormalities, the Q Relay disconnects the Enphase Microinverters from the AC grid, and when the voltages return to normal and the grid frequency is in the acceptable range, the Q Relay reconnects the system. The Q Relay works with the Envoy-S to break both line and neutral, when needed, per grid requirements.

Enphase Relay controller, Three Phase - Rubicon Partner portal


Easy to Install

  • Lightweight and simple
  • DIN rail mount for quick installation

Reliable

  • Dependable load control
  • Automatically resets when normal voltage resumes

Smart

  • Performs voltage and frequency ride-through
  • Remote upgrade capability
  • Easy to read LEDs
Rubicon Sustainable Technology Applications

Enphase Relay controller is utilized in the following areas:

  • Residential
  • Small Commercial (0 - 50kW)
Enphase training

Enphase Training

This course teaches you all about Enphase microinverters. It will show you were the Enphase microinverters are connected, how they are connected to the Enphase module and to the DB board, and all the benefits of Enphase microinverters. It will also teach you all about how to access the Enphase module via Wifi and show you all the monitoring capabilities.

Learning Management System now available to all Rubicon eCommerce account holders

Complete this course to get points towards your Rubicon Glass score for Lead referrals.

NRCS RCC - Rubicon Partner Portal

Regulators Compliance Certificated issued for the product by the NRCS in compliance with SANS 10142 Safety Regulations

Pollution degree: 2

Nominal input voltage (Vnom): 230 Vrms

Operating AC voltage range for power supply: 85 to 265 Vrms

Nominal input frequency: 50 Hz

Voltage and frequency acquisition time on
valid input during normal operation: 100 ms (5 line cycles @ 50Hz) 

Number of voltage inputs to monitor: 1

Number of Q Relays per system: Limit of 20 active Q Relay devices per system

Output: Four pole normally open relay (L1, L2, L3, and N)

Output power rating: 4.8kVA

Output rating (typical): 230 Vrms, 25A

Power consumption: 18 VA

LEDs: Four red/green LEDs: three for under/over voltage trip, one for under/over frequency and DC current

Mounting: 35 mm DIN rail (standard)

Width: 107mm

Surge - L1 N output: Combination (1kV 2Ω)

Operating temperature range: -40 °C to 50 °C

IP rating: IP 20 (Must be used in a protected environment)

Relative humidity: 0 to 95 non-condensing

Enphase Relay controller, 4-pole, 1/2/3 phase, 25A
You have successfully subscribed!
This email has been registered